Koolance ICM-505 User Manual download pdf (Page 16)

User Manual

Each tubing connection uses a threaded compression ﬁ tting (“hose screw”) to keep

it secure. To connect these components:

Connecting Hoses

Thread a hose screw onto the tube

end.

Squeeze the tube while pushing it

ﬁ rmly over the nozzle. Tubing should

completely cover the nozzle.

Tighten the connection by sliding the compression

fitting down over the nozzle and screwing

securely.

Nozzles are designed to attach tightly. If you need to remove a hose for any reason,

it may not pull off easily, even after unscrewing the compression ﬁ tting.

Usually, a connection will come free by squeezing the hose on top of the nozzle

and pulling away. If this fails, cutting a small incision lengthwise (parallel) along the

nozzle should free it.

When a hose screw has been removed,

it may have distorted the tubing beneath

it. This last portion (about 1cm, 7/16”)

should be trimmed to ensure a perfect ﬁ t

with the next connection. The tip should

always be re-cut if you needed to remove

the hose with an incision.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Koolance ICM-505 User Manual Page 16